Cool Power Solutions Oy

The TDM-C400 is ADSL/ADSL2+ customer premise equipment that provides high-speed asymmetrical data transmission on a single twisted copper pair. The DSL line interface supports various ADSL standards, up to ADSL2+. At the DTE side these CPEs provide, dual interfaces, a 10/100 Ethernet interface and one USB port for easy connection to user’s PC or LAN environment. TDM-C400 delivers broadband access for enterprises, telecommuters, home, and remote office workers with high-speed data transfer requirements.

Pyydä tarjous
Liity postituslistalle

Compliant with ITU-T G.992.1 (G.dmt), G.992.2 (G.lite) and ANSI T1.413 Issue 2
TDM-C400 is additionally compliant with ITU-T G.992.3 (G.dmt.bis / ADSL2), G.992.5 (ADSL2+) and provides up to 24 Mbps downstream rate
Compatible and interoperable with major Central Office side ADSL DSLAM or Multi-service Access System
One 10/100 Base-TX Ethernet port and one USB 1.1 device port for PC / LAN connection
RFC2684 / 1483 to bridge or route traffic over ATM over ADSL
Support Networking protocols such as PPP, IP routing, NAPT, relay / client
Support local and remote configuration and management through Web, Telnet or SNMP
Simple firmware upgrade via TFTP, FTP or HTTP
5-Year Warranty

Hardware
LAN Interface	One 10/100 Base-TX Ethernet port, IEEE 802.3/3u, RJ-45 connector One USB 1.1 device port, type B connector
WAN Interface (ADSL line)	One pair (2-wire) loop, 100 Ω line impedance with RJ-11 connector Compliance of X8821r: ITU-T G.992.1, G.992.2 and ANSI T1.413 Issue 2 Compliance of X8821r+: ITU-T G.992.1, G.992.2, G.992.3, G.992.5 & ANSI T1.413 Issue 2
Indicators	USB (green LED) – Continuous ON when USB is active; blinking while transmitting / receiving data LAN (green LED) – Continuous ON when Ethernet is active; blinking while transmitting / receiving data PPP (green LED) – Continuous ON when PPP connection is established; blinking while transmitting / receiving data WAN (green LED) – Continuous ON when ADSL link is up PWR (green LED) – Continuous ON when power is properly connected
OAM&P	Local: Telnet or Web management via Ethernet Remote: Telnet or Web Management
Power	AC adapter: Input 110/220VAC, 50/60Hz; Output 15VAC 1A Power consumption: Less than 6 Watts
Environment	Operation Temperature and Humidity: 0°C ~ 45°C,5% ~ 95% (non-condensing) Storage Temperature and Humidity: -20°C ~ 85°C, 5% ~ 95% (non-condensing)
Dimensions	170 mm ×121 mm × 36 mm
Weight	255g
Certifications	FCC, CE
Software
ATM	ATM cells over ADSL, AAL5 Supports 8 PVCs Supports UBR, CBR, rt-VBR, nrt-VBR and GFR traffic classes ADSL-aware CAC (Connection Admission Control) Support for F5 AIS, RDI, and loopback cells Payload encapsulation RFC2684 / RFC1483, Multiprotocol Encapsulation over ATM Adaptation Layer 5 RFC2225 / RFC1577, Classical IP and ARP over ATM(IPoA) RFC2364, PPP over AAL5 (PPPoA)
Bridging	RFC2684 / RFC1483 bridged PDU encapsulation IEEE 802.1D transparent bridging and spanning tree protocol ZIPB (Zero Installation PPP Bridge)
Routing	RFC2684 / RFC1483 routed PDU encapsulation Supports Point-to-Point Protocol (including PPPoA and PPPoE) and user authentication via PAP or CHAP Supports TCP, UDP, ARP, RARP, IPCP, ICMP, IGMP, etc. IP routing: static route, RIP v1 and v2 NAT/PAT with extensive ALG supports DNS relay agent Layer 2 tunneling protocol (L2TP)
Security	Built-in firewall with protection against DOS attacks, IP spoofing, and other common types of attacks Packet filtering at MAC layer (raw filter) and IP layer, including stateful packet filtering Supports blacklist
Configuration and Network Management	TR037-compliant auto-configuration using ILMI SNMP v1 agent – over IP, ILMI VCC or HDLC/EOC DHCP client, server and relay for IP management Universal Plug and Play (UPnP) support Telnet with CLI (command line interface) or Web-based configuration and management FTP/TFTP or HTTP for firmware upgrade and configuration

TDM-C400 ADSL/ADSL2+ Ethernet / USB Combo Modem Router